岸线码头密度对河道水动力和污染物输移影响分析——以武汉河段为例

为研究岸线码头密度对河流水动力变化及污染物输移的影响,以武汉河段为例,基于Mike21模型建立了适用于该河段的平面二维水动力-水质模型,计算了长为9.6 km的岸线范围内布置不同密度码头群后引起的附近区域内水位、流速变化以及突发水污染事故后的自净能力变化,从空间差异性、最大变幅等角度对比了三者的差异,并归纳了码头密度与水动力条件、污染物浓度变幅之间的关系.结果 表明:(1)随着码头密度增加,工程区上游水位变化较流速更敏感,工程区及下游局部位置水位变幅较小,而流速变化较为敏感,表现为前沿主流区流速增大,近岸区流速减小;当码头密度大于1.25～2.5座/km的临界范围后,水动力条件随码头密度的变幅逐渐减缓.(2)修建码头后,受水动力变化影响,工程区河段上游污染物浓度变化呈"峰前减、峰后增",但工程区下游呈"峰前增、峰后减"的特征;工程区间内表现为主流区浓度增大、近岸带浓度减小、高浓度滞留时间总体增加的变化特点.(3)受码头工程群影响,无论是区间整体上,还是局部范围内,污染物浓度相对水动力条件变幅更大,对河段内水源地的取水可能造成不利影响.以上认识对于河流岸线开发利用规模选取和效应评估具有参考意义.     

A combined radical and non-radical oxidation processes for efficient degradation of Acid Orange 7 in the homogeneous Cu(II)/PMS system: important role of chloride

Environmental Science and Pollution Research - Trace copper ion (Cu(II)) in water and wastewater can trigger peroxymonosulfate (PMS) activation to oxidize organic compounds, but it only works under...     

同步辐射光谱技术在有机固废污染控制与资源化研究中的应用

有机固废中碳、磷、硫及重金属等元素赋存形态是决定其环境行为、反应活性及资源化再利用的关键因素.同步辐射光谱技术可以在分子水平、微纳米尺度原位表征有机固废中碳、磷、硫、重金属等元素赋存形态、结合位点、微观结构,为深入阐明有机固废环境行为、反应机制提供直接的证据.概述了X射线吸收光谱、微束X射线荧光光谱等同步辐射光谱技术在有机固废污染控制与资源化研究的中应用进展,并对同步辐射光谱技术在该领域应用前景和发展趋势进行了展望,以期为有机固废资源化再利用及其污染控制等研究提供参考.     

秦巴山区降雨侵蚀力时空变化特征

降雨侵蚀力时空变化特征的研究对区域土壤侵蚀风险评估及水土保持规划具有重要的意义。利用秦巴山区及周边地区共63个气象站1961~2016年的逐日降雨量数据计算各站的降雨侵蚀力，借助Kriging空间插值法、Mann-Kendall趋势检验、Pettitt突变检验等方法分析了秦巴山区降雨侵蚀力的时空变化特征。结果表明：秦巴山区年均降雨侵蚀力为3 696 MJ·mm/(hm²·h·a)，年内变化呈单峰型，7月最大，占全年的26.6%；四季中，夏季最大，冬季最小。代际间，20世纪80年代的降雨侵蚀力最大，90年代最小。年际间，年降雨侵蚀力存在明显的阶段性，但未表现出显著的趋势性和突变性特征。秦巴山区多年平均降雨侵蚀力呈南高北低的分布格局，不同地区年均降雨侵蚀力变化于787~8 858 MJ·mm/(hm²·h·a)之间；整体而言，年降雨侵蚀力随纬度增加而减小，随海拔升高而减小。     

典型地区农用地污染调查及风险管控标准探讨

针对《土壤污染风险管控标准——农用地土壤污染风险管控标准》(GB 15618—2018),提出以土壤中全量浓度筛选值和管控值作为衡量农用地土壤污染风险管控的标准,对湖南省部分稻田农用地土壤及点对点稻米样品中镉、铅、砷、汞的总量和有效态浓度及稻米中含量进行监测,根据重金属总量浓度分为低风险、中风险、高风险3组。结果显示:(1)土壤及稻米中镉含量基本为随着风险级别的升高而增加,铅、砷在土壤和稻米中含量无规律性结果,汞监测结果均为未检出。(2)低风险组稻米镉超标率为12. 0%,高风险组稻米镉达标率为33. 3%,表明利用总量浓度对农用地土壤潜在风险进行分组存在一定的局限性。(3)依据4种重金属在土壤中总量及稻米(早稻)中含量情况,对风险级别进行调整并综合判断:有58个样品为低风险组,占样品总数的68. 2%,超标率为零;有15个样品为中风险组,占样品总数的17. 7%,超标率为80. 0%;有12个样品为高风险组,占样品总数的14. 1%,超标率为100. 0%。调整后评价结果与上述标准的划分目标更接近,能够提高上述标准的准确性和实用性。     

Effects of intercropping with floricultural accumulator plants on cadmium accumulation in grapevine

Environmental Science and Pollution Research - Grapevine (Vitis vinifera L.) intercropping with floricultural cadmium (Cd) accumulator plants (Helianthus annuus L., Cosmos sulphureus Cav., Cosmos...     

Probabilistic health risk assessment of nitrosamines in drinking water of Shaoxing,Zhejiang, China

Environmental Science and Pollution Research - Nitrosamines (NAms) are potent genotoxic and carcinogenic but widely detected in drinking water. This study aimed to investigate the occurrence of...     

Elevation of biochar application as regulator on denitrification/NH3 volatilization in saline soils

Environmental Science and Pollution Research - Denitrification and NH3 volatilization are the main removal processes of nitrogen in coastal saline soils. In this incubation study, the effects of...     

冷空气在北上台风“利奇马”致灾暴雨中的作用分析

利用NCEP逐6 h再分析资料、地面加密观测、探空、雷达资料,分析得出“利奇马”致灾暴雨是在长时间稳定维持的天气尺度环流背景下形成的。冷空气在降水所起的作用表现在:(1)长时间维持的弱冷空气与偏南暖湿气流交汇形成了边界层辐合线,辐射升温和暖湿气流的输送加大了辐合线两侧的温度和露点梯度,在高温高湿的有利环境下,对流在辐合线附近强烈发展。(2)高空槽后冷空气由“利奇马”环流西北侧渗入,先后形成3个冷平流中心,分别对应3个阶段的降水。(3)冷暖空气在降水区的持续辐合抬升作用增强了降水,最强降水时段发生在锋区垂直方向坡度最大的时段。(4)水平锋生有利于水汽输送和辐合抬升,垂直锋生有利于对流不稳定能量的累积和触发。冷空气形成的水平辐合和抬升造成大范围上升运动,使得锋生和垂直锋消同时存在,最强降水时段发生在水平锋生最强的时段。     

Comparison on surface properties and desulfurization of MnO2 and pyrolusite blended activated carbon by steam activation

In this study, MnO₂ and pyrolusite were used as the catalysts to prepare modified activated carbon, that is, AC-Mn and AC-P, respectively, from coals by blending method and steam activation. The Brunauer–Emmett–Teller (BET) results indicated that the AC-P had higher surface areas and micropore volumes than the AC-Mn with the same blending ratio. The relative contents of basic functional groups (i.e., C = O, π-π*) on AC-P were slightly lower than those on AC-Mn, while both contained the same main metal species, namely, MnO. The desulfurization results showed that with 3 wt% of blending ratio, AC-Mn3 and AC-P3 had higher sulfur capacities at 220 and 205 mg/g, respectively, which were much higher than for the blank one (149.6 mg/g). Moreover, the AC-P had relatively higher sulfur capacity than the AC-Mn with the same contents of Mn, which might be attributed to the existence of other metals in pyrolusite. After the desulfurization process, MnO were gradually transferred into MnSO₄, and the relative contents of basic functional groups decreased evidently for both AC-Mn3 and AC-P3. The results demonstrated that pyrolusite could be one good alternative to MnO₂ to prepare modified activated carbon for desulfurization.

Implications: MnO₂ and pyrolusite were used as the additives to prepare modified activated carbon from coals by a blending method and by steam activation, that is, AC-Mn and AC-P, respectively. The AC-P had higher surface areas and micropore volumes than the AC-Mn with the same blending ratio. The AC-Mn and AC-P had higher sulfur capacities than a blank one. Moreover, the AC-P had relatively higher sulfur capacity than the AC-Mn with the same contents of Mn. The results demonstrated that pyrolusite could be one good alternative to MnO₂ to prepare modified activated carbon for desulfurizatio.